Cone Joints with drip tip, Unprinted
Product Code : EL-GJ-10253
Lab Glassware Manufacturer is a leading India-based Cone Joints with Drip Tip, Unprinted manufacturer, supplier and exporter, headquartered in Ambala, Haryana, and serving laboratory glassware buyers since 1982. This drip-tip cone joint is exported to institutional and industrial buyers across Iceland, Ireland and the United Kingdom, supporting laboratory procurement throughout the North Atlantic Isles.
Quick Answer: A Cone Joint with Drip Tip is the male half of a standard ground-glass taper joint, extended with a short drawn-out tip below the taper that channels the last drops of liquid away cleanly instead of running down the outer glass surface. It is supplied unprinted (without a printed size marking) and is used in distillation and reagent-transfer assemblies where controlled run-off matters.
| Socket Size | Approx. O.D. of Tube (mm) | Total Length (mm) |
|---|---|---|
| 12/21 | 9 | 120±10 |
| 14/23 | 13 | 120±10 |
| 19/26 | 16 | 120±10 |
| 24/29 | 22 | 150±15 |
| 29/32 | 26 | 150±15 |
| 34/35 | 30 | 150±15 |
| 40/38 | 36 | 150±15 |
| 45/40 | 40 | 150±15 |
| 50/42 | 45 | 150±15 |
| 55/44 | 50 | 150±15 |
Sizes above are manufacturer-stated; confirm current dimensional tolerances with Lab Glassware Manufacturer before ordering.
Why Choose a Drip-Tip Cone Joint?
The plain Joints Cone Unprinted ends flush at the base of its taper, while this drip-tip version extends a short drawn-out point beyond the taper base. That extra tip directs the final drops of liquid to fall cleanly away from the joint rather than trailing down the outside of the glassware, which is useful in distillation, extraction and reagent-transfer setups where minimising residue and cross-contamination between runs matters. As with the standard cone joint, this drip-tip version must be paired with a socket of the identical size for a correct seal, and is available across ten standard taper sizes from 12/21 up to 55/44.
Frequently Asked Questions
What does the drip tip do?
It is a short drawn-out point extending beyond the taper base that directs the final drops of liquid to fall cleanly away, rather than running down the outer glass surface.
Does the size numbering work the same as a standard cone joint?
Yes, the first number is the joint's top outer diameter in millimetres and the second its taper length; both must match a mating socket joint of the same size.
What sizes are available?
Lab Glassware Manufacturer supplies this drip-tip cone joint across ten standard taper sizes from 12/21 up to 55/44, listed in the specification table above (manufacturer-stated – confirm before ordering).
Does Lab Glassware Manufacturer export this joint to the North Atlantic region?
Yes, Lab Glassware Manufacturer, based in Ambala, Haryana, India and manufacturing laboratory glassware since 1982, exports Cone Joints with Drip Tip to institutional and industrial buyers in Iceland, Ireland, the United Kingdom and other North Atlantic Isles markets.
Related Products
Joints Cone Unprinted | Socket Joints Unprinted | Keck Clips For Joints | Glass Joints | Laboratory Glass Joints
Request a Quote
For pricing, bulk-order and export enquiries on the Cone Joints with Drip Tip, Unprinted, contact Lab Glassware Manufacturer via our Contact Us page, or view current institutional and government supply opportunities on our Tenders page.
Last updated: September 2026